Become a Piping Design Engineer
Our Piping Engineering courses are entirely based on ASME B31.3 code. Our students will acquire knowledge that is equivalent to about two years industry related experience. Students are exposed to the latest piping techniques as related to the oil & gas industry. They get to know the different types of pipe welds available, the various units the OD's of Pipes are measured in, the method of pipe sizing and pump selection, how to use AutoCAD to make out Piping isometric drawings and so on.
Piping Design & Layout
This Course introduces you to the fundamentals of Piping Engineering. It also reaches out into the art of Piping Layout and Design. It is a complete Course as students will be taught how to draw and interprete piping systems.
You will learn how to produce GA drawings, Isometrics, Unit plot plans by hand and via AutoCAD, how to use the AutoCAD software, how to route and analyze piping systems and make adequate recommendations.
Stress analysis/CAESER II
This Course introduces students to the static and dynamic loadings that occur on a piping system. In here, students must make several calculations and recommendations that will ensure that the Piping stresses are within code allowable limits, the Piping end reactions are within allowable limit, the Piping system is properly supported. You will also be introduced to the CAESER II software which is used to simulate both static and dynamic loadings on a piping system and simulate the effects of supports on them.
3D Plant Design Using PDMS
Tekniprep offers you the unique opportunity to learn how to make piping layout and structural representations in 3D using the Plant Design Management System (PDMS) software. Students will learn the use of the software using modules. It shall be divided into Piping, Structural and Equipment modules. Students shall also learn how to use the software to extract key details such as the Piping isometric details, Piping material specification details and so on.